I need some help troubleshooting my Cuddelink system. I'm running a G-2+ cell cam with five J-2 remotes; everything is on FW 8.3.0. I configured the LINK IDs at home and confirmed that all the remotes connected to the G-2. I then installed the remotes and cell cam on my property. I installed the three of the remotes before I put up the cell cam, but when I powered it up, it found every one. The lowest signal I had was 44.
The problem is that the G-2 takes hundreds of pictures of an empty field. I get an email every 14 minutes with 31 thumbnail pictures of an empty field. I changed a few settings remotely a day after install, and it seemed to resolve. But it started happening again. I foolishly sent a take pic command to each of the remotes. This resulted in SD cards loaded with hundreds of pictures, minutes apart. Each remote ended up with 251 images in queue, but all I get in email is the field pic from the cell cam.
Today, I visited each camera, confirmed the SD was loaded with useless pics with an external reader. I ran the CLEAR command on each remote cam's SD and then powered it off. Then I went to the G-2, cleared the SD, pulled the batteries, waited, powered it back up. I then armed each remote and left as I was running out of light. When I ran a report I saw that the remotes still had 251 images in queue. I remotely cleared the queue which worked on all but one. Everything was quiet for a couple hours, but now, once again, I am getting emails with 31 pics of my field...
Just reviewing the report, I see a difference in the CL version between the cell and remotes: cell has 1.0.44/5.5.11, remotes are all 1.0.44.
Any insight would be appreciated.