Recent content by NC_AL

John, we run two networks as we took advantage of the free homebase promotion last year. I thought I read somewhere with 8.1 and above a K-Series camera cannot act as a remote? We had planned on only running a single network and using the other K camera as a remote when the 1 year of service...

Willy - we have two networks running and one of the K base cameras is doing the same as you described. Randomnly locks up with "Armed" on the display. Tried different types of batteries, external battery, resetting the camera, reflashing firmware, upgrading to 8.2. Nothing has resolved the issue...

John, We are noticing on multiple cameras on two seperate networks where some pictures are being captured to the card but not transmitted to camp or email. We are running 8.0 Has anyone experienced this type of problem? Could we have something set incorrectly? Sent from my SM-G975U using...

John, When using an external battery box with the cudde 12v external cable with a (6)D K-Series can you additionally use internal recharables or alkalines? Or should the camera internals be empty? Thanks again Al Sent from my SM-G975U using Tapatalk

John, Need a little advice about a J camera which is functioning oddly. I have had power issues with it and it appears to burn through batteries much quicker than any of our other 13 cameras. I switched it back a (4) D config using a PW3600 to try to resolve the issue and its back to low...

@Hoytvectrix - how are you connecting your cameras to a 12v battery? I need to find a better solution for our K base unit and a few heavily wooded areas to keep them powered. Any help on the battery being used, cabled,etc would be greatly appreciated. Sent from my SM-G975U using Tapatalk

John, Is there a document that describes how the system evaluates the voltage between the panel or banks and decides which one to use? I'm still confused if it was running on 6d recharables why it wouldn't run the internals down until it was below the panel at which time it would switch over to...

Understood. Just looking to understand how to best utilize the 3600 with the 12AA and 6D battery packs as we deployed 13 of them early this year. What happens if I install the second 7.4 battery pack in the panel? Will it see the panel now as 14.8v and run off it until it falls below the...

What happens if I install the second 7.4 battery pack in the panel? Will it see the panel now as 14.8v and run off it until it falls below the internals? And yes I am running 12AA and 6D rechargeables.

I recently purchased a PW-3600 and a little confused about the different charging scenarios. Mode 1: Using the brown ends cord provides 7.2v output from the PW3600 internal batteries to power the camera Mode 2: Using the yellow ends cord provides 12v from the PW3600 panel itself to charge an...

We currently have a standard K-Base with solar but looking at add a battery booster or potentially use the new solar panel with built-in batteries? What is the best option to use all rechargeable batteries and solar while increasing battery capacity? Thanks in advance

So I'm a little confused about the push toward D batteries if there is no way to recharge them via solar? I understand the desire to run alkaline D batteries in locations with little or no sun but for many of us running solar is every bit a part of the ability to not disturb the hunting...

John - Can you point me to the part number for the 12AA battery pack or where I can order them?

John - Has any testing be done with Rechargeable D batteries for the new J-series? I've recently tried two different brands with the same results.... The batteries drop to just a little over 1000 MaH (out of the potential 8 - 10k) per D battery within a day based on the DL field being returned...

John, Can an unlocked base (K Series Camera) later be used as a remote if you have multiple?