Recent content by MadMadHoosier

  1. MadMadHoosier

    Cuddelink L series Q & A

    Pretty sure the yellow connector on the old solar is straight off the solar panel and bypasses the batteries in the panel all together. No need to use it at all unless you are doing something exotic or old school. If you are in full sun, just use the brown connector, and if you are not in full...
  2. MadMadHoosier

    Cuddelink L series Q & A

    From my perspective using a power bank with cam and sun and shade panel would be a total waste. The panel with back up batteries in the cam have my cams running for 2 years (so far) without touching them. If I remember correctly. The brown connector on both panels use the panels internal...
  3. MadMadHoosier

    Sitka 40% Off Code

    Thanks so much. I did not realize the sale ended yesterday when I asked for the code, and was not back on this forum until this morning.
  4. MadMadHoosier

    Sitka 40% Off Code

    If any codes are still available, I’d sure appreciate one!
  5. MadMadHoosier

    Shooting range

    We have a shooting lane down a narrow power line clearing coming to the cabin. It’s amazing how many times a deer walks or trots across the lane WHILE we are shooting. It is like they are coming to check out what is going on. We are convinced one is going to run into a bullet one of these days.
  6. MadMadHoosier

    Cuddelink general Q&A recommendations

    We have 3 set ups. 1 with an L and 2 still on Gs. 60 cams total, so it will be a while before they all become Ls. And I saw John’s follow up reply. Thanks!
  7. MadMadHoosier

    Cuddelink general Q&A recommendations

    So if we updated to 3.0 and 9.0, should the system now automatically update to 3.1 and 9.1? I’m guessing not, because mine have not yet.
  8. MadMadHoosier

    Federal Primers

    I’ve been looking for Federal LMR “Match” primers for about 10 years. On 6/5/25, Natchez notified me they were in stock and I bought 4000. Out of stock again, so who know how long before the next batch???
  9. MadMadHoosier

    Cuddelink general Q&A recommendations

    Great. Appreciate all the new features and keep them coming. However, even if I had looked at that “i” it would have taken a while to figure out where to remove the cameras. Being married to a technical writer who used to do online and written help, I notice when the help could be… more...
  10. MadMadHoosier

    Cuddelink general Q&A recommendations

    I updated cam firmware to 3 & 9 last week, and on one set replaced a few J/G cameras with new L cams. After 7 days those disconnected cams are still showing on the report. Previously disconnected cams would drop off the report in a few days. When can I expect these to go away?
  11. MadMadHoosier

    Cuddelink L series Q & A

    I’m a day in with Gen 3 and besides an occasional crash of the new app, really loving it. Two questioned. 1: The hi res images look great at 2MP, but is it my imagination, or do the .3MP low res images look better than they used to? 2: Is there any way to add images to categories on the app...
  12. MadMadHoosier

    Cuddelink L series Q & A

    The update finally showed up for me. And I’ve set a couple camera to hi res and just saw the results. VERY NICE!
  13. MadMadHoosier

    Cuddelink L series Q & A

    Well nevermind. I looked in the App Store before sending the above reply, then looked again right after hitting send, and the update was there???
  14. MadMadHoosier

    Cuddelink L series Q & A

    What is the version of the new app? It looks like I’m on version 2.0, and that is the latest I see available in the App Store. How do I get the newest? Do you have a screen shot of the location to designate hi res?
  15. MadMadHoosier

    Cuddelink L series Q & A

    I’ve always used camp on a web browser, and am not sure if the IOS app is the new or old. But I cannot find any settings to have select cameras send higher resolution. So I'm guessing old, and no newer version seems available. Any suggestions or direction to get me on track? Very excite to try...
Back
Top