Recent content by mpresto

I recently set up a new L series camera as the remote to a K series camera as a home camera. Yesterday I got the cell report but for some reason I didn’t get it this morning. Any idea what might be wrong. The K camera is hooked up to a battery back and the L camera is hooked up to a solar panel.

I’ve tried formatting two different SD cards and updating the firmware and it still says check sd

What does it mean when it says check SD. I’m trying to update firmware on a G cell camera. It’s a new SD card

Remote access is currently unavailable at this time. Once the Cell device connects, remote access will be available again. If devices do not come back online after 48 hours, we suggest going to the cell device to verify it’s powered on and has sufficient cell service This is what popped up on...

Okay, thanks. Hopefully that’s the issue. Just frustrating

What problems were you encouraging?

Hello, yesterday I just setup my Cuddelink system. I used a K series camera for the home camera and 4 J series cameras. I ran cell test for the home camera and it sent me the email. So then yesterday I put all the cameras out and they all had good service back to the home camera. But I never did...