Recent content by Kb_303

Been a couple years since ive had a problem, but tried deploying a few extra cams this week and cannot get a J to link up. Ive reset the cam, triple checked the channel, swapped antennas and still cannot get a link level even when feet from the the home cam or the remotes. Thanks in advance for...

Ive got them all working again. Thanks so much for help!

After a few minutes of arm flashing, it now says error 04.

Hada network that went dead on me over 7 weeks ago. Finally got back home today for Thanksgiving and ran down there to check it out. K cell cam showed error 45, now i cant get anything on screen and the arm lights flash. Removed batteries and reset, still same problem.....

2 issues going on right now. 1. Cam #4, west, has been taking pictures but I don't ever see any transmitted to me, or find them on the camp. 2. Cam #5, flats, has a DPB hooked up to a no internals J. It has been going back and forth between ext 1, ext 2, and now OK. Every time it does this it...

Its been a whole day, I get my pics via email, but verizon setup isnt working for texts...

Recently changed my cell sevice to spectrum mobile. I do not see spectrum as an option when setting up to have pics sent to text. Any help here???

Sounds like the 2 cams may be stuck in wrong battery mode. This is a relatively new issue thats started to come up. If you have a 6 d booster, plug that in and see if it works. Then change battery settings to 4d.

7.9 will function fine, but you will not gain access to all the new online features, like being able to adjust camera settings remotely, for one. I believe 7.9 is available under the green update firmware button on the site. For 8.3 there is a grey " get gen 2" to the right of the green button...

Not john here, but i just had this exact scenario happen on a J cam. Had it sent back to cuddeback, and apparently its a terminal problem, because they sent back an entirely new camera. I had made contact through their online help request submissions. They emailed back within 2 days with a work...

I have a K camera that i recently fell back to old firmware on due to transmission delay issues. The firmware on website ended up being 7.5. Transmission is working fine now but the K camera is having some issues with flash i believe. Lots of seemingly blank dark pics, but then works during...

So i updated around noon today on a network of 5 cams on 80 acres. I used second number of 3. Pics are rolling in, in a much faster fashion already. Why can i not use number lower than 16?

I Id take a copy of 7.9 if you had it. That way i can swap it out next time im down, and than wait for 8.2

Any word on fixing transmission delay issues? What started as one system out of 3 for me has now progressed to all 3 separate networks sending small batches of pictures from one time period every hour or so throughout the day. I'll be getting pics taken at 7 am today in small batches all day...

Ive had this problem as well. I bought a bunch of the metal wrapped cords from cuddeback. There were some instances with older cams and solar panels, where cudde doesnt offer the metal option. In that case i took duct tape and coated it with cayenne pepper and laid it flat with cord centered in...